Digital Sphygmomanometer Detects Systole Diastolic Display
Abstract
Hypertension. characterized by elevated blood pressure against artery walls. can be influenced by a patient's body temperature. Therefore. detecting body temperature before measuring blood pressure is essential for accurate assessment. Currently. Digital Tension and Body Temperature parameters are typically evaluated separately. To address this. we propose a novel approach to combine these parameters into a single unit. enhancing health monitoring. Utilizing MPX5050GP for blood pressure and MLX90614 for body temperature detection. Both sensors are directly connected to the Arduino UNO microcontroller. enabling seamless data processing and display on the Nextion LCD. Experimental results demonstrate the device's effectiveness. with systolic blood pressure measurements showing a Maximum error: 2.23%. minimum error: 0.53% for systolic measurements. Diastolic measurements have with a remarkable maximum error of only 4.69% and a minimal error of 1.79%. Additionally. the body temperature measurements exhibited a Achieved exceptional precision with errors as low as 0.45% and a maximum of 1.65%. Successfully completed. this design facilitates simultaneous measurement of two vital parameters. Its potential to streamline health monitoring could significantly impact hypertension management and other related conditions. Further validation and implementation in clinical settings are anticipated to enhance its utility and benefits.
Downloads
References
P. J. Colquitt, “Will the millimetre of mercury be replaced by the kilopascal? [2],” J. Hypertens., vol. 17, no. 2, pp. 305–306, 1999, doi: 10.1097/00004872-199917020-00017.
C. A’Court, R. Stevens, S. Sanders, A. Ward, R. McManus, and C. Heneghan, “Type and accuracy of sphygmomanometers in primary care: A cross-sectional observational study,” Br. J. Gen. Pract., vol. 61, no. 590, pp. 598–603, 2011, doi: 10.3399/bjgp11X593884.
G. I. Varughese and G. Y. H. Lip, “Goodbye Mercury? Blood Pressure Measurement and Its Future,” J. R. Soc. Med., vol. 98, no. 3, pp. 89–90, 2005, doi: 10.1177/014107680509800301.
S. N. Mahmood and E. Ercelecbi, “Development of Blood Pressure Monitor by Using Capacitive Pressure Sensor and Microcontroller,” Int. Iraqi Conf. Eng. Technol. its Appl. IICETA 2018, pp. 96–100, 2018, doi: 10.1109/IICETA.2018.8458099.
T. Panula, J. P. Sirkia, D. Wong, and M. Kaisti, “Advances in Non-Invasive Blood Pressure Measurement Techniques,” IEEE Rev. Biomed. Eng., vol. 16, pp. 424–438, 2023, doi: 10.1109/RBME.2022.3141877.
Y. Wan et al., “Determining which automatic digital blood pressure device performs adequately: A systematic review,” J. Hum. Hypertens., vol. 24, no. 7, pp. 431–438, 2010, doi: 10.1038/jhh.2010.37.
K. A. Johnson, D. J. Partsch, P. Gleason, and K. Makay, “Comparison of two home blood pressure monitors with a mercury sphygmomanometer in an ambulatory population,” Pharmacotherapy, vol. 19, no. 3, pp. 333–339, 1999, doi: 10.1592/phco.19.4.333.30936.
R. Mukherjee, S. Ghosh, B. Gupta, and T. Chakravarty, “A Literature Review on Current and Proposed Technologies of Noninvasive Blood Pressure Measurement,” Telemed. e-Health, vol. 24, no. 3, pp. 185–193, 2018, doi: 10.1089/tmj.2017.0068.
K. Tan, M. H. F. Rahiman, R. A. Rahim, M. Jaysuman, and S. Buyamin, “Online micro-controller non-invasive blood pressure monitoring system (E-BPM),” J. Teknol. (Sciences Eng., vol. 54, pp. 403–423, 2011, doi: 10.11113/jt.v54.824.
M. G. Myers, M. R. Nelson, and G. A. Head, “Automated office blood pressure measurement for routine clinical practice,” Med. J. Aust., vol. 197, no. 7, pp. 372–373, 2012, doi: 10.5694/mja11.11545.
A. J. Puspitasari, E. Endarko, and I. Fatimah, “Blood Pressure Monitor Design Using MPX5050GP Pressure Sensor and Visual C# 2010 Express,” J. Fis. dan Apl., vol. 15, no. 3, p. 99, 2019, doi: 10.12962/j24604682.v15i3.4929.
J. Wiesel, D. Wiesel, R. Suri, and F. C. Messineo, “The use of a modified sphygmomanometer to detect atrial fibrillation in outpatients,” PACE - Pacing Clin. Electrophysiol., vol. 27, no. 5, pp. 639–643, 2004, doi: 10.1111/j.1540-8159.2004.00499.x.
M. G. Myers, “Why automated office blood pressure should now replace the mercury sphygmomanometer,” J. Clin. Hypertens., vol. 12, no. 7, pp. 478–480, 2010, doi: 10.1111/j.1751-7176.2010.00301.x.
T. Valler-jones and K. Wedgbury, “Measuring blood pressure using the mercury sphygmomanometer,” vol. 14, no. 3, pp. 145–150, 2005.
O. E. J., I. O. O., O. O. O., and O. O., “Development of a real time blood pressure, temperature measurement and reporting system for inpatients,” Int. J. Phys. Sci., vol. 11, no. 17, pp. 225–232, 2016, doi: 10.5897/ijps2016.4514.
D. V. Reddy and Y. Sreenivasulu, “Body Temperature & Blood Pressure Remote Monitoring,” IJMTST | Int. J. Mod. Trends Sci. Technol., vol. 1, no. 1, 2015.
I. Jahan, M. L. Rahman, A. W. Reza, and S. Das Barman, “Systolic blood pressure measurement from heart rate using IoT,” Int. J. Recent Technol. Eng., vol. 7, no. 4, pp. 135–138, 2018.
K. Wedgbury and T. Valler-Jones, “Measuring blood pressure using an automated sphygmomanometer.,” Br. J. Nurs., vol. 17, no. 11, pp. 714–718, 2008, doi: 10.12968/bjon.2008.17.11.29642.
N. M. Van Popele et al., “Arterial stiffness as underlying mechanism of disagreement between an oscillometric blood pressure monitor and a sphygmomanometer,” Hypertension, vol. 36, no. 4, pp. 484–488, 2000, doi: 10.1161/01.HYP.36.4.484.
E. O’Brien, “Consequences of banning mercury and the cuff controversy,” Blood Press. Monit., vol. 5, no. 1, pp. 33–34, 2000, doi: 10.1097/00126097-200002000-00007.
Alamsyah, M. Subito, S. Dewi, and A. Amir, “Heartbeat and Blood Pressure Monitoring System Wireless-Based,” Proc. - 2019 Int. Semin. Appl. Technol. Inf. Commun. Ind. 4.0 Retrosp. Prospect. Challenges, iSemantic 2019, pp. 503–506, 2019, doi: 10.1109/ISEMANTIC.2019.8884316.
C. Kaegi, M. C. Thibault, F. Giroux, and D. Bourbonnais, “The interrater reliability of force measurements using a modified sphygmomanometer in elderly subjects,” Phys. Ther., vol. 78, no. 10, pp. 1095–1103, 1998, doi: 10.1093/ptj/78.10.1095.
Mr. Mahavir K. Beldar1, “Design and Development of Arm Manikin for Blood Pressure and nPulse Simulation,” Ijmer, vol. 4, no. 5, pp. 37–49, 2014, [Online]. Available: http://www.ijmer.com/papers/Vol4_Issue5/Version-5/IJMER-45053749.pdf
R. J. McManus, J. Mant, M. R. P. Hull, and F. D. R. Hobbs, “Does changing from mercury to electronic blood pressure measurement influence recorded blood pressure? An observational study,” Br. J. Gen. Pract., vol. 53, no. 497, pp. 953–956, 2003.
C. A. Martin, J. D. Cameron, S. S. Chen, and B. P. McGrath, “Measurement of blood pressure in the office,” Hypertension, vol. 56, no. 1, pp. 420–442, 2010, doi: 10.1161/HYPERTENSIONAHA.110.154625.
Copyright (c) 2023 Farahun Nisa Aulia, Andjar Pudji, Sumber and Naqeeb Ullah
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
